Programming The ATTx V2 System 
------------------------------

» Step 1 - Plug a transmitter into each of your alarms and turn them on.

» Step 2 - On the ATTx V2 receiver, depress the program button and switch on whilst keeping the program button depressed. Keep the program button depressed for 5 seconds until all 5 LEDS light simultaneously. Let go of the program button, the first LED will flash.

» Step 3 - "Beep" your first alarm once only, the first LED will go out and second LED will flash. "Beep" your second alarm once only, the second LED will go out and third LED will flash. 
Repeat Step 3 until you have completed programming all the required channels.

» Step 4 - If you have less than 5 alarms/transmitters, any remaining channels can be skipped by beeping the last alarm until the remaining LEDs have gone off.

The system will exit "programme mode" in a few seconds and is ready for use. Alternately, switch the system off to exit "programme mode" then switch it back on.

Skipping Channels 
-----------------

During the program mode, if you tap the program button once, the flashing LED will go out and next LED will flash, by doing this you can use any selection of LED colors or positions. 
For example, if you have programmed channel 1, and LED 2 is flashing, signifying that it is ready to be programmed, do not beep your second alarm, instead hit the programme button once to skip channel 2. LED 2 will go out LED 3 will flash, ready for programming.


Save This Document 
------------------

If you are displaying this file in your browser, use the 'Save As' (Internet Explorer) or 'Save Page As' (Firefox) on the File Menu.
Click the back button on your browser to return to the ATT Website.

Print This Document
------------------- 

If you are displaying this file in your browser, use the 'Print' option on the File Menu of your browser.
Click the back button on your browser to return to the ATT Website.


Advanced Technology Tackle Ltd
http://www.attackle.com