Programming The ATTx V2 System 
------------------------------

» Step 1 - Plug a transmitter into each of your alarms and turn them on.

» Step 2 - On the ATTx V2 receiver, depress the program button and switch on whilst keeping the program button depressed. Keep the program button depressed for 5 seconds until all 5 LEDS light simultaneously. Let go of the program button, the first LED will flash.

» Step 3 - "Beep" your first alarm once only, the first LED will go out and second LED will flash. "Beep" your second alarm once only, the second LED will go out and third LED will flash. 
Repeat Step 3 until you have completed programming all the required channels.

» Step 4 - If you have less than 5 alarms/transmitters, any remaining channels can be skipped by beeping the last alarm until the remaining LEDs have gone off.

The system will exit "programme mode" in a few seconds and is ready for use. Alternately, switch the system off to exit "programme mode" then switch it back on.

Skipping Channels 
-----------------

During the program mode, if you tap the program button once, the flashing LED will go out and next LED will flash, by doing this you can use any selection of LED colors or positions. 
For example, if you have programmed channel 1, and LED 2 is flashing, signifying that it is ready to be programmed, do not beep your second alarm, instead hit the programme button once to skip channel 2. LED 2 will go out LED 3 will flash, ready for programming.


Changing the Receiver Tone
-------------------------- 

» Step 1 - Depress program button (don’t release) and switch receiver on.

» Step 2 - Keep the program button depressed for 5 seconds until all LEDs light simultaneously but do not release the program button. After a further 5 seconds all LEDs will go out simultaneously.

» Step 3 - Release the program button Let go of program button, the receiver will "chirp" once, signifying that it has entered entered into “Tone Choice Mode”

» Step 4 - Tap the program button to change the tone. Tapping the program button will cycle through a choice of 15 tones, with the receiver sounding a different tone every time the button is pressed .

» Step 5 - Switch the receiver OFF to save the last "chirped" tone and exit the “Tone Choice Mode”.


Activating the Vibration Function
---------------------------------

When the receiver is switched on, tap the program button quickly 4 times within 3 seconds, the vibration motor will vibrate momentarily to indicate that vibrate mode is ON.

Tap the program button quickly for 4 times within 3 seconds again and the speaker will sound once to indicate cancellation of the vibration motor.

Save This Document 
------------------

If you are displaying this file in your browser, use the 'Save As' (Internet Explorer) or 'Save Page As' (Firefox) on the File Menu.
Click the back button on your browser to return to the ATT Website.

Print This Document
------------------- 

If you are displaying this file in your browser, use the 'Print' option on the File Menu of your browser.
Click the back button on your browser to return to the ATT Website.


Advanced Technology Tackle Ltd
http://www.attackle.com