ATTX V1 - System Set-Up
-----------------------
 
» Step 1 - Hold down the program button located on the right hand facing side of the receiver and then switch it on.
Keep the button depressed until all the LEDs light up and then release the program button.

» Step 2 - "Beep" the alarm that you want on the channel until the LED goes out. If you want to skip the channel, hold the program button down and "beep" the alarm.
Once the LED switches off, release the program button and you are ready to program the next channel.
Repeat Step 2 until you have completed programming all the required channels.

» Step 3 -Any remaining channels can be skipped by holding in the program button and beeping any alarm until the last LED is off. Once the last LED is off, release the program button.
The system is now ready for use.


Save This Document 
------------------

If you are displaying this file in your browser, use the 'Save As' (Internet Explorer) or 'Save Page As' (Firefox) on the File Menu.
Click the back button on your browser to return to the ATT Website.

Print This Document
------------------- 

If you are displaying this file in your browser, use the 'Print' option on the File Menu of your browser.
Click the back button on your browser to return to the ATT Website.


Advanced Technology Tackle Ltd
http://www.attackle.com