The ATTx V2 System > Advanced Set-Up
Activating the Vibration FunctionWhen the receiver is switched on, tap the program button quickly 4 times within 3 seconds, the vibration motor will vibrate momentarily to indicate that vibrate mode is ON.
Tap the program button quickly for 4 times within 3 seconds again and the speaker will sound once to indicate cancellation of the vibration motor.
Changing the Receiver Tone » Step 1 - Depress program button (don’t release) and switch receiver on.
» Step 2 - Keep the program button depressed for 5 seconds until all LEDs light simultaneously but do not release the program button. After a further 5 seconds all LEDs will go out simultaneously.
» Step 3 - Release the program button, the receiver will "chirp" once, signifying that it has entered entered into “Tone Choice Mode”
» Step 4 - Tap the program button to change the tone. Tapping the program button will cycle through a choice of 10 tones, with the receiver sounding a different tone every time the button is pressed.
» Step 5 - Switch the receiver OFF to save the last "chirped" tone and exit the “Tone Choice Mode”.