The ATTx V1 System > System Set-Up
Programming The ATTx System
Programming your transmitter units into your receiver is a task you are required to do once only.
Keep the button depressed until all the LEDs light up and then release the program button.
» Step 2 - "Beep" the alarm that you want on the channel until the LED goes out. If you want to skip the channel, hold the program button down and "beep" the alarm.
Once the LED switches off, release the program button and you are ready to program the next channel.
Repeat Step 2 until you have completed programming all the required channels.
» Step 3 - Any remaining channels can be skipped by holding in the program button and beeping any alarm until the last LED is off. Once the last LED is off, release the program button.
The system is now ready for use.
NOTE:- Adding additional transmitter units to your set up at a later date will require complete reprogramming of your system.