The ATTx V1 System > System Maintenance
Fitting & Changing the Transmitter Batteries
» Remove the battery slide from the Transmitter Unit
» Place a CR1025 cell with the +ve side up, into the the lower battery recess, i.e. the recess furthest from the jack plug numbered 1 on the diagram
» Fit the remaining CR1025 cell with the +ve side down into the the remaining battery recess, numbered 2 on the diagram
» Refit the battery slide, it completes the electrical circuit.
System Care
» Always store the units in the supplied case to ensure maximum protection.
» Remove transmitters from the alarms by grasping the jack plug only.
» DO NOT remove the transmitters by pulling on the bulbous end or transmitter stalk.
» If the units are not used for long periods of time, it is recommended that the batteries are removed to reduce the risk of damage from possible battery leakage and corrosion.