The ATT Car Pager - Installation
The ATT Pager System can be installed by any qualified auto-electrician and can interface with your existing vehicle alarm system. Unless you are competant at auto-electronics, we advise that you have the pager system professionally installed.
Main Harness Connections
» BLACK - Ground Connection - The Ground cable must be connected to an independent bodywork earth point.
» RED - 12V Positve (+ve) Connection - Connect this cable via a 1 amp in-line fuse to a suitable +ve 12 volts constant supply.
» YELLOW - Ignition Connection - Connect this cable via a 1 amp in-line fuse to a wire that supplies +Ve 12 volts when the ignition switch in the ‘auxiliary’ position.
» BLUE - Negative (-VE) Door Switch Connection - Connect this cable into the ‘Diode Pack’ blue wire. NOTE: If a diode pack isn’t used, connect this wire directly to your boot and bonnet point contacts.
» GREEN - Door, Boot and Bonnet Connection - 4 green wires from exit of diode pack are to be connected to door point earth trigger contacts and boot and bonnet contacts.
Main Harness Connections» BLACK - Ground Connection - The Ground cable must be connected to an independent bodywork earth point.
» RED - 12V Positve (+ve) Connection - Connect this cable via a 1 amp in-line fuse to a suitable +ve 12 volts constant supply.
» YELLOW - Ignition Connection - Connect this cable via a 1 amp in-line fuse to a wire that supplies +Ve 12 volts when the ignition switch in the ‘auxiliary’ position.
» BLUE - Negative (-VE) Door Switch Connection - Connect this cable into the ‘Diode Pack’ blue wire. NOTE: If a diode pack isn’t used, connect this wire directly to your boot and bonnet point contacts.
» GREEN - Door, Boot and Bonnet Connection - 4 green wires from exit of diode pack are to be connected to door point earth trigger contacts and boot and bonnet contacts.